Agreed. Does it have two Ts? Then it's not datta which you just instinctively rest as dah-ta
massacre
I assume you refer to Putin. But you come of ambiguously for those who don't realize Finland isn't an aggressor. Really more of a FAFO type county. Don't fuck with the Finns.
oh, never looked into that
they do... look into polyurethane
I have both i nthe pic still (actually 2 of each). The little stand to make the OG into an alarm clock was tip top
I'm pretty sure Ireland is now the richest country in the EU
I had to downvote this to keep it at 42. I'm sorry - I couldn't let the 43 stand.
I'm sure the instrument in question to discharge the debt references the special trust they believe is setup for them as a Corporation in their name at birth. And somehow the government owns the trust and despite the same government funding this trust, they hope you never use it so the government can get the money back. That's how they try to discharge the debt towards this mythical trust that, if you just know enough magical sovcit phrases, you can access as the 'natural' person named in the trust.
it's like arcane wizardry...
Blue, black or red inks, and wet ink means something different. All capital letters, especially on names. Making sure to incant with the law using the correct statues (and statutes), citing the specific sections of case law. And sprinkle in a mighty, but perfect amount of phrasing like "All Rights Reserved".
Sometimes you are too low level at this and that lack of experience leads to imperfections and you just have to keep trying until the spell works on the right person in authority. Trust me, I got my degree from Trump University. It's a bigly degree.
I guess I can show you how, but I'd have to barter for fiat currency - unfortunately my car broke down and that's the only thing my mechanic will take. He doesn't understand Coupons (note the capital) !
Don't fret! 95+% all servers on the internet run Linux so the attack vector has been there for ages. Follow best practices and your risk will remain low!
Not for this purpose, but for a diy metalwork (foundry, milling, etc) project I have in mind, I'd really like to see how this works.