37
What's a good method for a non-technical person to short the terminals of two 0402 resistors ~1mm apart?
(lemmy.world)
I'm working on a mod kit for a popular item, but my target audience isn't likely to have a soldering iron. The majority of the project connects to an exposed ribbon connector, but I need to short two terminals to force a power supply on.
Any ideas on a method I could provide for people who can't solder? Maybe a strip of copper tape?
Yeah, the GVDCVG is ground, voltage, data, and clock. My board is going to sit between this ribbon cable and the part that normally connects there.
You do make a good point though. I was hoping for an elegant solution where this ribbon cable was the only connected component, but there's a large exposed voltage testpoint exposed nearby. It's 1.5mm wide and 3mm from the board edge. I bet I can find a miniature allegator clip or some other way to connect to that.
I tell people to take apart an ancient junk switching supply wall wart with a hammer and unwrap a winding from the transformer inside. That gives easy access to a small bit of enameled copper wire. They will need to be extreme about scraping the enamel to get to the copper. It is also a good idea to use a lighter to heat the enamel and scrape some more. Then they can wrap the exposed copper part around something like that transistor lead a dozen or more times like it is an old wire wrap job. If you can locate two such locations where a lead with an air gap exists, it is possible to make that connection.