Buildapc

3807 readers

1 users here now

founded 1 year ago

MODERATORS

Lemmenmo@lemmy.world

Removed my SLI and extra 1080, started up fine, froze, and now video won't display (lemmy.world)

submitted 1 month ago* (last edited 1 month ago) by 5oap10116@lemmy.world to c/buildapc@lemmy.world

32 comments fedilink hide all child comments

Im building my wife a PC and now that my SLI is useless (for a few years now), I figured I'd give her my extra GPU.

I disabled the SLI in the control panel, powered down, popped the SLI and 2nd GPU out and gave my wifes pc the extra 1080. My PC started up fine, I booted up a game, and about 10 min in, the screen froze for about 10 seconds and then appeared to restart and now I have no video output. Did I brick my gpu? Any ideas on how to proceed?

I'm only panicking a lot.

you are viewing a single comment's thread
view the rest of the comments

[–] givesomefucks@lemmy.world 6 points 1 month ago* (last edited 1 month ago) (1 children)

I know it sounds stupid...

But when you cut your GPU power almost in half... You turned settings down a lot right?

That would cause the crash, and sometimes a crash just kinda sticks, no fans, no lights, no output.

You have to flip the switch on the supply and do the hardest of reboots.

Like I said, you probably already did that stuff. But I've seen it happen.

The first thing you should always do is try turning it off and on again

[–] 5oap10116@lemmy.world 2 points 1 month ago

So I've had my SLI disabled for a few years now because no games still support it, so I know I can run these games on a single card.

I've already done the hard PS switch reset.

Everything lights up in the case itself but no video output comes out.