this post was submitted on 23 Sep 2024
353 points (99.2% liked)
Memes
45643 readers
1153 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
It's always a resistor. Planned obsolescence is basically putting a too small resistor somewhere. The parts they make for repair shops are usually better, so if you do take the time to swap a print, you will have a better appliance afterwards for a fraction of the cost of a new shitty machine.
Soldering the specific resistor can be done too, but for anyone who doesn't have a stock of resistors and soldering tools/skill it's usually a easier and just as cheap to get new print if they're available.