102
Are there any good Blu-ray ripping software for Linux?
(lemmy.blahaj.zone)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 12 Jul 2023
102 points (96.4% liked)
Linux
47366 readers
2109 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
What settings are you using and what CPU?
I used to transcode blu-ray movies with handbrake in H.264 using an i7-950 and it only took a few hours for a 2 hour movie.
Try using the x.264 encoder in handbrake set to constant quality mode. Set the CRF to around 20-22 and use the fast preset.
The slower presets significantly increase the encode time with only a small decrease in file size.
Keep in mind that the RF values will be completely different if you use other encoders like H.265 or even H.264 with a hardware acceleration encoder. For 1080p, 20-22 is indeed appropriate but lower res like 480p will require a lower RF like 16-18 for the same quality. Meanwhile 4K will be fine with 24. Again, assuming you use the x264 encoder which is not hardware accelerated. For best results, I'd really recommend playing around with the settings and see what works best for you.