Star Trek
r/startrek: The Next Generation
Star Trek news and discussion. No slash fic...
Maybe a little slash fic.
New to Star Trek and wondering where to start?
Rules
1 Be constructive
All posts/comments must be thoughtful and balanced.
2 Be welcoming
It is important that everyone from newbies to OG Trekkers feel welcome, no matter their gender, sexual orientation, religion or race.
3 Be truthful
All posts/comments must be factually accurate and verifiable. We are not a place for gossip, rumors, or manipulative or misleading content.
4 Be nice
If a polite way cannot be found to phrase what it is you want to say, don't say anything at all. Insulting or disparaging remarks about any human being are expressly not allowed.
5 Spoilers
Utilize the spoiler system for any and all spoilers relating to the most recently-aired episodes, as well as previews for upcoming episodes. There is no formal spoiler protection for episodes/films after they have been available for approximately one week.
6 Keep on-topic
All submissions must be directly about the Star Trek franchise (the shows, movies, books etc.). Off-topic discussions are welcome at c/quarks.
7 Meta
Questions and concerns about moderator actions should be brought forward via DM.
Upcoming Episodes
Date | Episode | Title |
---|---|---|
11-14 | LD 5x05 | "Starbase 80?!" |
11-21 | LD 5x06 | "Of Gods and Angles" |
11-28 | LD 5x07 | "Fully Dilated" |
12-05 | LD 5x08 | "Upper Decks" |
12-12 | LD 5x09 | "Fissue Quest" |
In Production
Strange New Worlds (2025)
Section 31 (2025-01-24)
Starfleet Academy (TBA)
In Development
Untitled comedy series
Wondering where to stream a series? Check here.
view the rest of the comments
The not damaging the paint part is the best news about this method. I will definitely look into it. Thanks!
Glad to help - I was surprised as well that they really didn’t take off even the cheap paint in my last rental. I had some quite heavy framed mirrors stuck up. When the time comes you have to be a bit careful pulling them off - follow the instructions carefully when doing so. You have to push down on the bit stuck to the wall quite hard and then pull the tab along the wall until it stretches right out and it all comes off perfectly.