31
rate my router sled setup
(lemmy.world)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 17 Sep 2024
31 points (97.0% liked)
Woodworking
6047 readers
1 users here now
A handmade home for woodworkers and admirers of woodworkers. Our community icon is a planter box made by @Captain Aggravated, the winner of our summer '24 woodworking contest. Congratulations!
founded 1 year ago
MODERATORS
If you're not getting any flex in that aluminum, then it should be fine. MDF has its durability issues but as long as it's dry, it's ridiculously stable.
100% that aluminum is flexing, the question is how much matters to OP? A CNC router has far beefier extruded aluminum gantries but still flexes from the weight of the router, although typically less than a mil. My guess would be at least 10-15mil with the aluminum angle.
OP said about 1/16", which would be what? 50 or 60 mil? Honestly, though, it's woodworking. In the right context, like coarse slab flattening, 1/16" might be fine, though I would reckon that the point where fine tuning by other means is not that bad would be closer to 1/32".
Yes totally true, just saying that there will always be some amount of flex.